Manual Shift Shaft Seal Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Manual Shift Shaft Seal

Courtesy of GENERAL MOTORS CORP.

Callout	Component Procedure
1	Manual Shift Shaft Seal CAUTION: Do not damage the case bore during removal of the manual shift shaft seal. CAUTION: When installing the seal, ensure the seal lip is firmly seated against the case bore surface. Do not allow the seal lip to be crushed, or a leak may result. CAUTION: Refer to Seal Reuse Caution . Special Tools DT 47770: Seal Installer J 45201: Cooler Line Seal Remover For equivalent regional tools, refer to Special Tools .

Callout

Component Procedure

Manual Shift Shaft Seal

CAUTION: Do not damage the case bore during removal of the manual shift shaft seal.

CAUTION: When installing the seal, ensure the seal lip is firmly seated against the case bore surface. Do not allow the seal lip to be crushed, or a leak may result.

CAUTION: Refer to Seal Reuse Caution .

Special Tools

DT 47770: Seal Installer
J 45201: Cooler Line Seal Remover

For equivalent regional tools, refer to Special Tools .