Fluid Pump Cover Installation

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fluid Pump Cover & Bolt Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Fluid Pump Cover Assembly
2	Fluid Pump Cover Bolts M6 x 40 (Qty: 13) Tip: Hand tighten only.
3	Alignment Tool and Bolt CAUTION: Refer to Fastener Caution . Procedure Center the J 46664 around the fluid pump cover assembly in the 9 o'clock position and tighten the alignment bolt. See Special Tools . Tighten the fluid pump cover bolts in the sequence shown. Tighten: 11 N.m (97 lb in) Special Tool: J 46664: Pump Cover Alignment Tool For equivalent regional tools, refer to Special Tools .
4	NEW 1-2-3-4 and 3-5 Reverse Clutch Housing Thrust Washer