Control Valve Body Assembly Installation
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | NEW Fluid Pump Seal Assembly |
| 2 | NEW Fluid Pump Seal Assembly |
| 3 | NEW Center Support Fluid Passage Seal Assembly Tip: There are two different designs for the Center Support Fluid Passage Seal. The design for 6L45/50 (MYA/MYB) models utilizes tabs. The design for 6L80/90 (MYC/MYD) models does not have tabs. |
| 4 | Control Valve Body Assembly
CAUTION:
The control valve body assembly needs to be lowered into place vertically, with no lateral movement. Lateral movement can damage the pass through connector pins and/or the oil transfer seals. Tip: Align the manual shift shaft position switch activator slide with the detent lever guide pin. |
| 5 | Bolts M5 x 73 (Qty: 6)
CAUTION:
Refer to Fastener Caution
. Procedure: Tighten in the sequence shown. Tighten: 8 N.m (71 lb in). Special Tool: DT-48285: Valve Body Torx Plus Socket (if applicable) For equivalent regional tools, refer to Special Tools . |