Manual Shift Shaft Position Switch Installation
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | A/Trans Manual Shift Shaft Position Switch Assembly |
| 2 | Manual Valve Link Tip: Align the switch activator slide with the manual valve link. |
| 3 | Bolt M5 x 55 Tip: Hand tighten only. |
| 4 | A/Trans Manual Shift Shaft Position Switch Harness Clip Tip: The wiring harness clip on the manual shift shaft position switch does not need to be replaced if damaged or missing. The clip functions only as a manufacturing assembly aid to keep the harness clear during an automated bolt installation process. If the clip is damaged, simply remove and discard. |
| 5 | A/Trans Manual Shift Shaft Position Switch Electrical Connector Tip: Connect and lock the manual shift shaft position switch electrical connector to the control solenoid valve assembly. |