3-5 Reverse Clutch Piston Removal

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: 3-5 Reverse Clutch Piston

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Install the 1-2-3-4 and 3-5 reverse clutch housing assembly onto the torque converter (with fluid pump) housing assembly. Apply hand pressure on the 1-2-3-4 clutch piston housing while applying compressed air to the apply passage in order to unseat the 3-5 reverse clutch piston.
1	1-2-3-4 Clutch Piston Housing Retaining Ring CAUTION: Refer to Retaining Ring Reuse Caution . Special Tool: DT 47867: Adjustable Clutch Spring Compressor For equivalent regional tools, refer to Special Tools .
2	1-2-3-4 Clutch Piston Housing
3	3-5 Reverse Clutch Spring
4	3-5 Reverse Clutch Piston Tip: It may be necessary to turn the housing assembly upside down and carefully tap the housing against a flat surface in order to release the piston.