LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1588 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Right Side (JH6, JH7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Cable Eye & Park Brake Actuator Lever
    GM1862970Courtesy of GENERAL MOTORS CORP.
  1. Connect the right park brake cable eye (3) to the park brake actuator lever (2).
  2. Install the park brake cable to the rear axle bracket by pulling the cable conduit (1) rearward to compress the spring and inserting the cable conduit into the rear axle bracket.
    3. Fig 2: Park Brake Cable Mounting
    GM1862968Courtesy of GENERAL MOTORS CORP.
  3. Connect the park brake cable (1) to the rear axle housing cover clip.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the park brake cable clip bolt (2) and tighten to 22 N.m (16 lb ft).
    5. Fig 3: Right Park Brake Cable & Equalizer
    GM1862965Courtesy of GENERAL MOTORS CORP.
  5. Insert the park brake cable conduit (2) into the frame bracket.

    Ensure the locking tabs on the cable conduit are fully engaged into the frame bracket.

  6. Connect the right rear park brake cable to the equalizer (1).
  7. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
  8. Adjust the park brake. Refer to Parking Brake Adjustment (1500 Drum Brake)  or Parking Brake Adjustment (1500 Disc Brake)  or Parking Brake Adjustment (2500/3500 SRW)  or Parking Brake Adjustment (3500 DRW) .
scientia non olet · About LEMON Manuals