Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Park Brake Cable Conduit & Park Brake Cable Eye

Courtesy of GENERAL MOTORS CORP.

Connect the right park brake cable eye (2) to the park brake actuator lever.
Install the park brake cable to the rear axle bracket by pulling the cable conduit (1) rearward and inserting the cable conduit into the rear axle bracket.
Ensure the locking tabs on the cable conduit are fully engaged into the rear axle bracket.

Fig 2: Park Brake Cable Mounting

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the park brake cable clip bolt (2).
Tighten: Tighten the bolt to 22 N.m (16 lb ft).
Connect the park brake cable (1) to the rear axle housing cover clip.

Fig 3: Park Brake Cable & Intermediate Cable Equalizer Bar

Courtesy of GENERAL MOTORS CORP.

Connect the right rear park brake cable (1) to the intermediate cable equalizer bar (2).
Insert the park brake cable conduit (3) into the frame bracket.
Ensure the locking tabs on the cable conduit are fully engaged into the frame bracket.
Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
Adjust the park brake. Refer to Parking Brake Adjustment (1500 Drum Brake) or Parking Brake Adjustment (1500 Disc Brake) or Parking Brake Adjustment (2500/3500 SRW) or Parking Brake Adjustment (3500 DRW) .