LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1588 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Left Side (JH6, JH7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Cable Eye & Park Brake Actuator Lever
    GM1862962Courtesy of GENERAL MOTORS CORP.
  1. Connect the left park brake cable eye (1) to the park brake actuator lever (2).
  2. Install the park brake cable to the rear axle bracket by pulling the cable conduit (3) rearward to compress the spring and inserting the cable conduit into the rear axle bracket.

    Ensure the locking tabs on the cable conduit are fully engaged into the rear axle bracket.

    3. Fig 2: Park Brake Cable Clip Bolt
    GM1862961Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the park brake cable clip bolt and tighten to 22 N.m (16 lb ft).
    4. Fig 3: Left Rear Cable
    GM1862954Courtesy of GENERAL MOTORS CORP.
  4. Insert the park brake cable conduit (2) into the equalizer (3).

    Ensure the locking tabs on the cable conduit are fully engaged into the equalizer.

  5. Connect the left rear park brake cable to the intermediate cable connector (1).
  6. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
  7. Adjust the park brake. Refer to Parking Brake Adjustment (1500 Drum Brake)  or Parking Brake Adjustment (1500 Disc Brake)  or Parking Brake Adjustment (2500/3500 SRW)  or Parking Brake Adjustment (3500 DRW) .
scientia non olet · About LEMON Manuals