LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1588 (Parking Brake System) >> Repair Instructions >> Parking Brake Indicator Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Warning Lamp Switch Mounting Bolt
    GM913316Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake warning lamp switch.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the park brake warning lamp switch bolt and tighten to 3 N.m (27 lb in).
    3. Fig 2: Park Brake Warning Lamp Switch Electrical Connector
    GM606395Courtesy of GENERAL MOTORS CORP.
  3. Connect the park brake warning lamp switch electrical connector.
  4. Install the left side instrument panel electrical center/junction block. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Left Side .
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) or Battery Negative Cable Disconnection and Connection (Dual Batteries) or Battery Negative Cable Disconnection and Connection (Auxiliary Battery) .
scientia non olet · About LEMON Manuals