Headlamp Replacement (Chevrolet)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Headlamp (Chevrolet)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the upper radiator grille. Refer to Radiator Grille Replacement (Chevrolet) or Radiator Grille Replacement (GMC) or Radiator Grille Replacement (Chevrolet HD) or Radiator Grille Replacement (GMC HD) . Behind the headlamp at the top of the front bumper access the lower inside hidden headlamp bolt. Loosen the bolt only, do not remove, the lower outside hidden headlamp bolt.
1	Headlamp Screws (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 6 N.m (53 lb in)
2	Headlamp Screw (Hidden) Tighten: 6 N.m (53 lb in)
3	Headlamp Housing Support Procedure Apply masking tape to the front bumper end caps to protect the painted surface. For the right side lamp assembly only, disengage the upper retainer for the radiator air baffle. Release the headlamp from the support tab, rotate the lamp assembly towards the center of the vehicle. Disengage the headlamp electrical connector from the forward lamp harness.