LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1337 (Wheel Drive Shafts) >> Repair Instructions >> Wheel Drive Shaft Replacement (1500) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Drive Shaft
    GM1736759Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel drive shaft in the steering knuckle.
    2. Fig 2: View Of Hub, Nut & Washer
    GM1736696Courtesy of GENERAL MOTORS CORP.
    NOTE: Install the NEW nut and washer, but DO NOT tighten at this time.
  2. Install the NEW nut (1) and washer (2).
    3. Fig 3: View Of Drive Flange & Retaining Bolts
    GM1736718Courtesy of GENERAL MOTORS CORP.
  3. Install the retaining bolts and finger tighten.
    4. Fig 4: Preventing Drive Axle From Turning
    GM1932Courtesy of GENERAL MOTORS CORP.
  4. Insert a drift or large screwdriver through the brake caliper into one of the brake rotor vanes in order to prevent the wheel drive shaft from turning.
    5. CAUTION: Refer to Fastener Caution .
  5. Tighten the wheel driver shaft retaining bolts and tighten to 79 N.m (58 lb ft).
  6. Tighten the wheel drive shaft retaining nut and tighten to 240 N.m (177 lb ft).
  7. Remove the drift or large screwdriver from the brake rotor.
  8. Install the shock module. Refer to Shock Absorber and Spring Assembly Replacement .
  9. Install the stabilizer shaft link from the lower control arm. Refer to Stabilizer Shaft Replacement (1500) or Stabilizer Shaft Replacement (2500, 3500) .
  10. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals