LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1336 (Power Steering System) >> Repair Instructions >> Power Steering Fluid Cooler Replacement (Without Hydroboost) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering fluid cooler to the vehicle.
    2. Fig 1: Removing Power Steering Cooler From The Vehicle (Without Hydroboost)
    GM686121Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the power steering fluid cooler bolts (2) to the power steering fluid cooler (1).

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    3. Fig 2: View Of Power Steering Pump & Components
    GM1861214Courtesy of GENERAL MOTORS CORP.
  3. Connect the power steering fluid cooler hose (3) to the power steering pump (1).
  4. Connect the power steering gear outlet hose (2) to the power steering fluid cooler (4).
  5. Clean any excess fluid from the vehicle and remove the drain pans.
  6. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
  7. Install the radiator grille. Refer to Radiator Grille Replacement (Chevrolet) or Radiator Grille Replacement (GMC) .
scientia non olet · About LEMON Manuals