Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Using the J 37624 (2) and the J 8092 (1), Install the inner pinion bearing cup into the pinion gear bearing retainer.
- Using the J 8608 (2) and the J 8092 (1), install the outer pinion bearing cup into the pinion gear bearing retainer. See Special Tools .
- Apply sealant to surface of the selective shim. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the pinion gear bearing retainer and bolts tighten to 88 N.m (65 lb ft).
- Install the drive pinion flange/yoke and/or oil seal. Refer to Drive Pinion Flange/Yoke and/or Oil Seal Replacement .
- Install the propeller shaft.
- For vehicles equipped with the one piece propeller shaft, refer to One-Piece Propeller Shaft Replacement .
- For vehicles equipped with the two piece propeller shaft, refer to Two-Piece Propeller Shaft Replacement .
- Install the rear axle shafts. Refer to Rear Axle Shaft and/or Gasket Replacement .
- Fill the axle with axle lubricant. Refer to Differential Oil Replacement (10.5 Inch Axle) or Differential Oil Replacement (11.5 Inch Axle) or Differential Oil Replacement (8.6 Inch Axle) or Differential Oil Replacement (9.5LD Inch Axle) .
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution
.