LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1307 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Refer to SIR Warning .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the steering column shroud. Refer to Steering Column Shroud Replacement .
  3. With the key installed hold it in the START position.
    4. Fig 1: Releasing/Installing Lock Cylinder Using Allen Wrench
    GM1413814Courtesy of GENERAL MOTORS CORP.
  4. Install an Allen wrench into the hole on top of the ignition lock cylinder case.

    Push down on the Allen wrench to release the tab on the ignition lock cylinder inside the ignition lock cylinder case.

    5. Fig 2: View Of Lock Cylinder At Lock Cylinder Housing
    GM1413837Courtesy of GENERAL MOTORS CORP.
  5. Slide the ignition lock cylinder out of the ignition lock cylinder case.
scientia non olet · About LEMON Manuals