Front Side Door Inside Handle Replacement (with SLT)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Side Door Inside Handle Assembly & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove door upper trim panel. Refer to Upper Extension Trim Panel Replacement . Remove door window control switch. Refer to Door Lock and Side Window Switch Replacement - Driver Side and Door Lock and Side Window Switch Replacement - Passenger Side . Remove door trim panel. Refer to Front Side Door Trim Panel Replacement (SLT, A95) or Front Side Door Trim Panel Replacement (Except YE9 or SLT) .
1	Front Side Door Inside Handle Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
2	Front Side Door Inside Handle Assembly Tip: Disconnect the electrical connector. If replacing the door handle, transfer heated seat switch to new handle. Refer to Front Seat Heater Switch Replacement .

Callout

Component Name

Preliminary Procedures

Remove door upper trim panel. Refer to Upper Extension Trim Panel Replacement .
Remove door window control switch. Refer to Door Lock and Side Window Switch Replacement - Driver Side and Door Lock and Side Window Switch Replacement - Passenger Side .
Remove door trim panel. Refer to Front Side Door Trim Panel Replacement (SLT, A95) or Front Side Door Trim Panel Replacement (Except YE9 or SLT) .

Front Side Door Inside Handle Bolt (Qty: 2)

CAUTION: Refer to Fastener Caution .

Tighten: 2 N.m (18 lb in)

Front Side Door Inside Handle Assembly
Tip:

Disconnect the electrical connector.
If replacing the door handle, transfer heated seat switch to new handle. Refer to Front Seat Heater Switch Replacement .