Front Side Door Trim Panel Replacement (Except YE9 or SLT)
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP.
| Callout |
Component Name |
|
Preliminary Procedure
- Remove upper extension trim panel. Refer to Upper Extension Trim Panel Replacement .
- Remove door pull handle. Refer to Front Side Door Pull Handle Replacement .
- Remove door lock and window control switch (if equipped). Refer to Door Lock and Side Window Switch Replacement - Driver Side
and Door Lock and Side Window Switch Replacement - Passenger Side
.
- Remove the door window regulator handle (if equipped). Refer to Door Window Regulator Handle Replacement
.
|
| 1 |
Front Side Door Locking Rod Knob Assembly
Tip:
- Lower window.
- Ensure locking rod is in the unlocked position.
- Use a flat-bladed tool to disengage detent tab and then remove knob by pulling upward.
- When re-installing, push knob down until detent tab touches locking rod opening cover.
- Push detent tab in to lock knob to locking rod.
|
| 2 |
Front Side Door Release Handle Cover |
| 3 |
Front Side Door Armrest Opening Cover |
| 4 |
Front Side Door Trim Panel Bolt (Qty: 3)
Tighten:
9 N.m (18 lb in)
|
| 5 |
Front Side Door Trim Panel Assembly
Tip:
- Depress both tabs to remove cable and pull cable rearward out of handle assembly.
- When reinstalling cable make sure that it is fully seated past the guide tab.
- There are two hooks located on the lower portion of the door trim panel that are being used for manufacturing installation ONLY.
- If these hook are damaged during either removal or installation of the door trim panel, replacement of the panel is not required.
|
| 6 |
Front Side Door Trim Panel Retainer (Qty: 11) |