Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Put the steering column in the uppermost tilted position.
- Install the spring guide (1) to the tilt spring (2).
- Install the tilt spring (1) onto the steering column (2) using the following procedure:
- Install the tilt spring (1) onto the post on the steering column tilt head (3).
- Install the tilt spring (1) onto the post on the steering column (2).
- Remove the locking pliers.
- Install the steering column shroud. Refer to Steering Column Shroud Replacement .
- Install the knee bolster. Refer to Knee Bolster Replacement (With RPO SLT) or Knee Bolster Replacement (Without RPO SLT) .
WARNING:
The tilt spring and the spring guide are under pressure. The tilt spring and the spring guide may become a projectile. Secure the spring with locking pliers during removal. Secure the spring with locking pliers during installation. Bodily injury may result during removal and installation of the tilt spring and the spring guide. Always use caution during removal and installation of the tilt spring and the spring guide.