Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Recirculation Actuator Screws

Courtesy of GENERAL MOTORS CORP.

Install the recirculation actuator.

NOTE: Refer to Fastener Notice .

Install the recirculation actuator screws (1).
Tighten: Tighten the screws to 1 N.m (9 lb in).

Fig 2: View of Electrical Connector From Recirculation Actuator

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector to the recirculation actuator.
Install the air inlet assembly. Refer to Air Inlet Assembly Replacement .