LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Engine Controls And Fuel - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Pipe Shield Replacement (LLT) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cross vehicle brace. Refer to Cross Vehicle Brace Replacement .
  2. Remove the fuel injection sight shield. Refer to Fuel Injector Sight Shield Replacement (LP1, LY7) or Fuel Injector Sight Shield Replacement (LLT)
    3. Fig 1: Removing/Installing Intake Manifold & Cylinder Bolts
    GM1977749Courtesy of GENERAL MOTORS CORP.
  3. Remove the fuel pipe shield to intake manifold bolts (1).
  4. Remove the fuel pipe shield to cylinder bolt (1).
  5. Carefully remove the fuel pipe shield from the vehicle. Take care not to damage the insulation behind the shield.
scientia non olet · About LEMON Manuals