LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Engine Controls And Fuel - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Pipe Shield Replacement (LLT) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Intake Manifold & Cylinder Bolts
    GM1977749Courtesy of GENERAL MOTORS CORP.
  1. Position the fuel pipe shield behind the high pressure fuel pump. Take care not to damage the insulation behind the shield.
  2. Install the fuel pipe shield to cylinder bolt (1). Hand tighten at this time.
    3. NOTE: Refer to Fastener Notice .
  3. Install the fuel pipe shield to intake manifold bolts (1).

    Tighten: 

    1. Tighten the Fuel pipe Shield to manifold bolts to 23 N.m (17 lb ft).
    2. Tighten the Fuel Pipe Shield to head bolt to 10 N.m (89 lb in).

  4. Install the fuel injection sight shield. Refer to Fuel Injector Sight Shield Replacement (LP1, LY7) or Fuel Injector Sight Shield Replacement (LLT)
  5. Install the cross vehicle brace. Refer to Cross Vehicle Brace Replacement .
scientia non olet · About LEMON Manuals