Installation Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure that the fuel feed pipe and fuel pump fittings are clean and dry prior to assembly.
- Position the fuel feed pipe (2) to the cylinder head and high pressure fuel pump.
- Install the fuel feed pipe fitting to the high pressure fuel pump hand tight.
- Install the fuel feed pipe bolts (4).
Tighten:
- Tighten the bolts to 50 N.m (37 lb ft).
- Tighten the fitting to 28 N.m (20 lb ft).
- Connect the fuel feed line quick connect fitting to the fuel feed pipe (2). Refer to Fuel Pipe Shield Replacement (LLT) .
- Inspect for leaks using the following procedure:
- Turn ON the ignition, with the engine OFF for 2 seconds.
- Turn OFF the ignition, for 10 seconds.
- Turn ON the ignition, with the engine OFF.
- Inspect for fuel leaks.
- Install the low side fuel pressure service port cap.
- Install the fuel tank cap.
- Install the radiator surge tank outlet pipe. Refer to Radiator Surge Tank Outlet Hose/Pipe Replacement (LLT) or Radiator Surge Tank Outlet Hose/Pipe Replacement (LY7/LLT) .
- Install the high pressure pump shield. Refer to Fuel Pipe Shield Replacement (LLT) .
- Install the fuel injection sight shield. Refer to Fuel Injector Sight Shield Replacement (LP1, LY7) or Fuel Injector Sight Shield Replacement (LLT) .
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
If a fuel leak accrues at the high pressure fuel pump, the pump will need to be replaced.