Rear Side Door Window Regulator Replacement

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Side Door Window Regulator Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
1	Rear Side Door Window Regulator Bolts (Qty: 4) NOTE: Refer to Fastener Notice . Procedure Remove the water deflector. Tape the window in the full up position. Connect the door trim panel wire harness connector. Loosen the window regulator to window clamp nuts 4 revolutions. Refer to Rear Side Door Window Replacement . Using the power window switch, lower the window regulator about 1/2 way down. Disconnect the electrical connector from the power window motor. Tighten: Tighten the bolt (1,2,3) to 9 N.m (80 lb in).
2	Rear Side Door Window Regulator Procedure Remove the tape from the window. Start the vehicle to ensure maximum power to the window motor. This is required to fully seat the window for adjustment.

Callout

Component Name

Preliminary Procedure:
Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .

Rear Side Door Window Regulator Bolts (Qty: 4)

NOTE: Refer to Fastener Notice .

Procedure

Remove the water deflector.
Tape the window in the full up position.
Connect the door trim panel wire harness connector.
Loosen the window regulator to window clamp nuts 4 revolutions. Refer to Rear Side Door Window Replacement .
Using the power window switch, lower the window regulator about 1/2 way down.
Disconnect the electrical connector from the power window motor.

Tighten: Tighten the bolt (1,2,3) to 9 N.m (80 lb in).

Rear Side Door Window Regulator

Procedure

Remove the tape from the window.
Start the vehicle to ensure maximum power to the window motor. This is required to fully seat the window for adjustment.