LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1110 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Rear Door Window Belt Inner Sealing Strip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Rear Door Window Belt Inner Sealing Strip
    GM428713Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When reusing the inner belt sealing strip, the flange mounting area must be pinched together in order to counteract the splaying effect when removed. Use a thumb and an index finger to pinch the carrier (3) back together.
  1. Work from one end of the sealing strip to the other.
    2. Fig 2: Identifying Rear Door Window Belt Inner Sealing Strip
    GM758767Courtesy of GENERAL MOTORS CORP.
  2. Position the inner belt sealing strip over the flange of the door inner panel.
    3. IMPORTANT: Do not distort the seal strip.
  3. Adjust seal strip gap (a) at the division post to 1.0 mm (0.04 in) maximum.
  4. Press downward to engage the sealing strip the entire length of the door.
  5. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals