Door Window Adjustment
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement or Rear Side Door Trim Panel Replacement .
- Pull down the upper portion of the water deflector far enough to access the window clamp nuts.
- Loosen the window regulator to window clamp nuts 4 revolutions.
- Connect the door trim panel wire connector.
- Start the vehicle.
- Using the power window switch, raise the window to the full up position.
Tighten: Tighten the window clamp nuts to 11 N.m (98 lb in).
- Inspect for proper window operation and a tight seal.
- Shut off the vehicle.
- Install the water deflector.
- Install the door trim panel. Refer to Front Side Door Trim Panel Replacement or Rear Side Door Trim Panel Replacement .
CAUTION:
Refer to Glass and Sheet Metal Handling Caution
.
CAUTION:
Refer to EXPRESS WINDOW DOWN CAUTION
Express Window Down Caution.
IMPORTANT:
Start the vehicle to ensure maximum power to the window motor. This is required in order to fully seat the window for adjustment.
NOTE:
Refer to Fastener Notice
.