LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1098 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Condenser Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new O-rings to the condenser tube. Refer to O-Ring Replacement .
  2. Install the A/C pressure sensor (1).
  3. Install the condenser tube.
  4. Connect the A/C pressure sensor electrical connector.
  5. Connect the condenser tube to the liquid line.
  6. Connect the condenser tube to the condenser.
    7. Fig 1: View Of Condenser Tube & A/C Pressure Sensor
    GM1563776Courtesy of GENERAL MOTORS CORP.
  7. Connect the condenser tube to the fan shroud retainer clip.
    8. NOTE: Refer to Fastener Notice .
  8. Install the condenser tube to condenser retaining bolt.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  9. Install the front air deflector. Refer to Front Bumper Fascia Air Deflector Replacement .
  10. Lower the vehicle.
  11. Install the A/C quick connect fitting at the liquid line. Refer to Air Conditioning Line/Tube Connector Removal/Replacement .
  12. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  13. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
  14. Using J 39400-A  , leak test the fittings of the component. See Special Tools .
scientia non olet · About LEMON Manuals