Driver Seat and Passenger Seat Recliner Handle Bezel Bracket Replacement

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Driver Seat and Passenger Seat Recliner Handle Bezel Bracket Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the front seat. Refer to Front Seat Replacement - Bucket . Remove the front seat adjuster switch bezel. Refer to Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement . Remove the front seat inner adjuster rear finish cover. Refer to Driver Seat and Passenger Seat Inner Adjuster Rear Finish Cover Replacement .
1	Front Seat Recliner Handle Bezel Bracket Screw (Qty: 6) NOTE: Refer to Fastener Notice . Tighten: 3 N.m (27 lb in)
2	Front Seat Recliner Handle Bezel Bracket

Callout

Component Name

Preliminary Procedure

Remove the front seat. Refer to Front Seat Replacement - Bucket .
Remove the front seat adjuster switch bezel. Refer to Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement .
Remove the front seat inner adjuster rear finish cover. Refer to Driver Seat and Passenger Seat Inner Adjuster Rear Finish Cover Replacement .

Front Seat Recliner Handle Bezel Bracket Screw (Qty: 6)

NOTE: Refer to Fastener Notice .

Tighten: 3 N.m (27 lb in)

Front Seat Recliner Handle Bezel Bracket