Rear Bumper Fascia Replacement

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Fascia Assembly Rear Bumper

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the right and left rear wheelhouse. Refer to Rear Wheelhouse Liner Panel Replacement . Remove the rear fog lamp assembly. Refer to Rear Fog Lamp Replacement (T79) . Remove the tire pressure indicator receiver. Refer to Tire Pressure Monitoring Receiver Replacement (RPO UH3) .
1	Rear Bumper Fascia Push Pin (Qty: 3)
2	Rear Bumper Fascia Screw (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
3	Rear Bumper Fascia Procedure Disconnect the electrical connectors/harnesses as needed. Transfer any parts as needed.