Front and Rear Housings Cleaning and Inspection
WARNING: This page is about a different variant/trim than selected.
- Clean the transmission extension in cleaning solvent, and air dry.
- Remove the sealer from the case sealing surface.
- Inspect the rear output bearing (3) for:
- Roughness
- Brinneling
- Pitting
- Replace the rear output bearing if any of the above conditions are found. Refer to Transmission Extension Disassemble .
- Inspect the case for being broken or cracked.
- Replace the case if it is broken or cracked.
- Inspect the sealing surfaces (2) for damage.
- Repair small scratches or nicks with a soft stone.
- Inspect the extension mounting for damage.
- Replace the extension if the mounting is damaged.
- Inspect the case threaded bolt holes for damage.
- Repair any damaged threads.
- Inspect for missing or loose location pins (1).
- Repair or replace any damaged dowel pins.
NOTE:
Refer to Machined Surface Damage Notice
.