Emergency Locking Retractors
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Perform this test in an area clear of other vehicles or obstructions. Do not conduct this test on the open road. A large, empty parking lot is suitable. Failure to observe this precaution may result in damage to the vehicle and possible personal injury.
- Fasten the seat belts, an assistant is needed when the retractor under test is not part of the driver seat belt.
- Accelerate the vehicle slowly to 16 km/h (10 mph) and apply the brakes firmly.
- Verify that the seat belt locks when braking firmly.
- If the belt does not lock, proceed with the following steps:
- Remove the seat belt retractor assembly.
- Tilt the seat belt retractor slowly.
- Ensure that the seat belt webbing can be pulled from the retractor at an inclination of 15 degrees or less and cannot be pulled from the retractor at an inclination of 60 degrees or more.
- If the seat belt retractor does not operate as described, replace the retractor assembly. Refer to the following procedures:
- Seat Belt Retractor Pretensioner Replacement - Front (Regular Cab) or Seat Belt Retractor Pretensioner Replacement - Front (Extended Cab) or Seat Belt Retractor Pretensioner Replacement - Front (Crew Cab)
- Seat Belt Replacement - Center Front
- Seat Belt Replacement - Center Rear (Extended Cab) or Seat Belt Replacement - Center Rear (Crew Cab)
- Rear Seat Belt Retractor Replacement (Extended Cab) or Rear Seat Belt Retractor Replacement (Crew Cab)