Sill Plate, Striker, Weatherstrip Replacement - Rear Compartment

WARNING: This page is about a different car, the 2005 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Compartment Sill Plate, Striker & Weatherstrip

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
Rear Compartment Sill Trim Plate Assembly Replacement
1	Plate Assembly, Rear Compartment Sill Trim Tip: Pull up to disengage the clips and remove.
2	Clip, Trim (Qty: 6)
Rear Compartment Lid Latch Striker Assembly Replacement
1	Plate Assembly, Rear Compartment Sill Trim Tip: Pull up to disengage the clips and remove.
2	Clip, Trim (Qty: 6)
3	Cable, Rear Compartment Emergency Release Refer to Handle Replacement - Rear Compartment Lid Interior Release .
4	Fascia Assembly, Rear Bumper Refer to Fascia, Bracket, Bar, Absorber Replacement - Rear Bumper in Bumpers.
5	Nut, Rear Compartment Lid Latch Striker (Qty: 3) Tighten: 12 N.m (9 lb ft)
6	Striker Assembly, Rear Compartment Lid Latch
Rear Compartment Lid Weatherstrip Assembly Replacement
7	Weatherstrip Assembly, Rear Compartment Lid