Ride Diagnosis

Did you review the General Description and perform the necessary inspections? If so, go to next step. If not, go to SYMPTOMS - SUSPENSION GENERAL DIAGNOSIS .
NOTE: Verify the vehicle suspension package RPO.
Verify the ride is too soft or too hard. Does the vehicle ride normally? If so, then system is okay. If not, go to next step.
Check the tire inflation and adjust to specifications. Did you adjust the tire pressure? If so, go to step 6. If not, go to next step.
Inspect the vehicle trim height. Refer to TRIM HEIGHT INSPECTION PROCEDURE . Did you find and correct the condition? If so, go to step 6. If not, go to next step.
Inspect the following suspension components for wear or damage.
- The shock absorbers. Refer to STRUTS OR SHOCK ABSORBERS ON-VEHICLE TESTING .
- The springs. Refer to FRONT COIL SPRINGS REPLACEMENT and TORSION BAR REPLACEMENT in FRONT SUSPENSION SYSTEM or LEAF SPRING REPLACEMENT .
Did you find and correct the condition? If so, go to next step.
Drive the vehicle in order to verify the repair. Did you correct the condition? If so, then system is okay. If not, go to step 3.