Struts Or Shock Absorbers On-Vehicle Testing
- Did you review the General Description and perform the necessary inspections? If so, go to next step. If not, go to SYMPTOMS - SUSPENSION GENERAL DIAGNOSIS .
- Verify that the customer's concern is present. Does the vehicle operate normally? If so, then system is okay. If not, go to next step.NOTE: A light film of oil on the top portion of the shock reservoir is normal.
- Inspect each strut or shock absorber for external fluid leakage. Is a strut or shock absorber leaking? If so, go to step 5. If not, go to next step.
- Use your hands in order to lift up and push down each corner of the vehicle 3 times. Remove your hands from the vehicle. Locate a shock or strut that exceeds 2 cycles. Did you locate a shock or strut that exceeds 2 cycles? If so, go to next step. If not, go to step 6.NOTE: Inspect the vehicle trim height in order to correct any possible causes of shock/strut failures. Refer to TRIM HEIGHT INSPECTION PROCEDURE .
- Replace the strut or shock absorber. Refer to SHOCK ABSORBER REPLACEMENT in FRONT SUSPENSION SYSTEM or SHOCK ABSORBER REPLACEMENT . After repair is complete, go to next step.
- Operate the vehicle in order to verify the repair. Did you correct the condition? If so, then system is okay. If not, go to step 3.