Conditions for Clearing the DTC
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- The conditions for setting the DTC are not currently present.
- The rear wheel steering control module receives a clear code command from the scan tool.
- The DTC clears after 100 malfunction free ignition cycles.
DTC C0533
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Rear Wheel Steering Schematics Connector End View Reference: Rear Wheel Steering Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check-Rear Wheel Steering? | Go to Step 2 | Go to Diagnostic System Check - Rear Wheel Steering |
| 2 | Inspect for poor connections at the rear wheel steering control module and the rear wheel steering motor connector. Refer to Testing for Intermittent Conditions and Poor Connections
andConnector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 5 | Go to Step 3 |
| 3 | Replace the rear wheel steering motor. Refer to Steering Gear Motor Assembly Replacement . Did you find and correct the condition? |
Go to Step 5 | Go to Step 4 |
| 4 |
IMPORTANT:
Perform the Learn Alignment procedure. Refer to Measuring Wheel Alignment (w/Rear Wheel Steering)Measuring Wheel Alignment (w/o Rear Wheel Steering)
in Wheel Alignment. Replace the rear wheel steering module. Refer to Rear Wheel Steering Control Module Replacement Did you complete the replacement? |
Go to Step 5 | |
| 5 |
|
Go to Step 2 | System OK |