Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the inside diameter of the NEW seal with J 36850.
- Using J 21426 and a soft faced mallet, install the seal.
- Remove the drain pan.
- Install the propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT -- REAR in. Propeller Shaft.
- Fill the transmission to the proper level with DEXRON® Ill transmission fluid. Refer to TRANSMISSION FLUID CHECKING PROCEDURE .