LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 758 (Washer System & Wiper System) >> Rear Washer Hose Removal/Installation

Rear Washer Hose Removal/Installation

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Slightly bend back the mudguard (RH).
  3. Disconnect the rear washer hose A from the washer tank.
  4. Remove rear washer hose A from clips A.
    Fig 1: Locating Rear Wiper Hose A & Retaining Clips
    G00974332Courtesy of MAZDA MOTORS CORP.
  5. Remove A-pillar trim (RH). (See A-PILLAR TRIM REMOVAL/INSTALLATION .)
  6. Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
  7. Remove the dashboard garnish. (See DASHBOARD GARNISH REMOVAL/INSTALLATION .)
  8. Disconnect joint pipe, then remove the rear washer hose A.
  9. Remove rear washer hose B from the clips B.
  10. Remove the following parts:
    1. Upper anchor of the front seat belt (See FRONT SEAT BELT REMOVAL/INSTALLATION .)
    2. Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    3. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION REAR SCUFF PLATE REMOVAL/INSTALLATION.)
    4. B-pillar lower trim (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION .)
    5. B-pillar upper trim (See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION N.)
    6. Rear seat (See REAR SEAT REMOVAL/INSTALLATION REAR SEAT REMOVAL/INSTALLATION.)
    7. Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
    8. Trunk side upper trim (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION .)
    9. C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
    10. Map light (See MAP LIGHT REMOVAL/INSTALLATION .)
    11. Sunvisor (See SUNVISOR REMOVAL/INSTALLATION SUNVISOR REMOVAL/INSTALLATION.)
    12. Assist handle (See ASSIST HANDLE REMOVAL/INSTALLATION ASSIST HANDLE REMOVAL/INSTALLATION.)
  11. Disconnect the joint pipe B.
  12. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION .)
  13. Remove rear washer hose B and the tapes.
  14. Remove clips C from the body.
  15. Disconnect the joint pipe C, then remove rear washer hose C.
  16. Remove rear washer hose D from the rear washer nozzle.
    Fig 2: Locating Rear Wiper Hose B & Retaining Clips
    G00974333Courtesy of MAZDA MOTORS CORP.
  17. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals