Turn Signal Cancel Cam and Bearing Thrust Washer - Assemble - Off Vehicle

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 23653-SIR Steering Column Lock Plate Compressor
J 42137 Cam Orientation Plate Adapter. See Special Tools and Equipment .

Fig 1: Thrust Washer, Upper Bearing Spring, Turn Signal Cancel Cam Assembly & Cam Orientation Plate

Courtesy of GENERAL MOTORS CORP.

Install the following parts onto the steering shaft assembly:
1. The thrust washer (1).
2. The upper bearing spring (2).
Lubricate the turn signal cancel cam assembly (3) with lithium grease.
Install the turn signal cancel cam assembly (3) onto the steering shaft assembly.
Install the cam orientation plate (4) onto the steering shaft assembly.

Fig 2: Compressing Cam Orientation Plate Using J 23653-SIR & J 42137

Courtesy of GENERAL MOTORS CORP.

Install the new bearing retainer onto the steering shaft assembly.
Compress the cam orientation plate using J 23653-SIR and J 42137 .
Firmly seat the bearing retainer into the groove on the steering shaft assembly.
Remove J 23653-SIR .
Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle .
Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM in SIR.