LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 644 (Steering Wheel & Steering Column) >> Repair Instructions >> Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle

Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Block Tooth Of Steering Shaft Assembly In 12 O'clock Position
    GM293254Courtesy of GENERAL MOTORS CORP.
  1. Align the block tooth on the steering column shaft assembly (1) to the 12 o'clock position.
  2. Place the ignition switch in the LOCK position.
    3. Fig 2: Wave Washer & Steering Shaft
    GM293252Courtesy of GENERAL MOTORS CORP.
  3. Install the wave washer (1) onto the steering column shaft assembly (2).
  4. If you are installing the existing inflatable restraint steering wheel module coil, you must center the inflatable restraint steering wheel module coil first. Refer to Inflatable Restraint Coil Centering - Off Vehicle (Column Shift And Floor Shift) .
    5. Fig 3: Turn Signal Cancel Cam Assembly, Steering Clumn Shaft Assembly, Retaining Ring & Inflatable Restraint Steering Wheel Module Coil
    GM415291Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The new inflatable restraint steering wheel module coil will be pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.
  5. Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
  6. Slide the new inflatable restraint steering wheel module coil (4) onto the steering column shaft assembly (2).
  7. Firmly seat the retaining ring (3) into the groove on the steering column shaft assembly (2).
  8. Remove the centering tab from the new inflatable restraint steering wheel module coil (4).
  9. Discard the centering tab.
    10. Fig 4: View Of Steering Column Wire Harness Assembly & Wire Harness Strap
    GM415293Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The abrasion sleeve must be installed back onto the steering column wire harness assembly. The electronic lock module assembly wires and connector must be hanging out of the middle of the abrasion sleeve.
  10. Reconnect the inflatable restraint steering wheel module coil connector to the turn signal switch assembly connector.
  11. Install the wire harness assembly (1) into the wire harness strap (2).
  12. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle (Column Shift Snap On Shrouds)  or Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift) .
  13. Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM in SIR.
scientia non olet · About LEMON Manuals