Inflatable Restraint Steering Wheel Module Coil - Disassemble - Off Vehicle
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Disable the inflatable restraint steering wheel module. Refer to DISABLING SYSTEM in SIR.
- Remove the upper and lower trim covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle (Column Shift Snap On Shrouds) or Steering Column Trim Covers - Disassemble - Off Vehicle (Floor Shift) .
- Remove the wire harness assembly (1) from the wire harness strap (2).
- Disconnect the inflatable restraint steering wheel module coil connector from the turn signal switch assembly connector.
- Remove the retaining ring (3) from the steering column shaft assembly by using snap ring pliers.
- Remove the inflatable restraint steering wheel module coil (2) from the steering column shaft assembly.
- Remove the wave washer (1) from the steering column shaft assembly.
CAUTION:
Refer to SIR CAUTION
in Cautions and Notices.
IMPORTANT:
The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector is coming out of the abrasion sleeve for installation purposes.