Steering Column Trim Covers - Disassemble - Off Vehicle (Column Shift Snap On Shrouds)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Lower Trim Cover Assembly

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to SIR CAUTION in Cautions and Notices.

Disable the inflatable restraint steering wheel module. Refer to DISABLING SYSTEM in SIR.
Remove the steering wheel from the column. Refer to Steering Wheel Replacement .
Remove the tilt lever from the lower trim cover. Refer to Tilt Lever Replacement - On Vehicle .

IMPORTANT: You must check for 2 pan head tapping screws (1,2) in the lower trim cover before removal.

If necessary, remove the 2 pan head tapping screws (1,2) from the lower trim cover (3). Remove the lower trim cover (3).
If screws are not present in the lower trim cover, proceed to the next step.

Fig 2: View Of Lower Trim Cover At Upper Trim Cover

Courtesy of GENERAL MOTORS CORP.

Gently unsnap the lower trim cover from the upper trim cover.

Fig 3: View Of TORX(R) Head Screw & Upper Trim Cover

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: You must check for 2 pan head tapping screws (1,2) in the lower trim cover (3) before removal.

If necessary, remove 1 TORX® head screw (1) from the upper trim cover (2).
If a screw is not present, remove the upper trim cover (2).