Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the upper trim cover (2) onto the steering column.
- Screw the 2 TORX® head screws (1) into the upper trim cover (2).
Tighten: Tighten the 2 TORX® head screws to 1.5 N.m (13 lb in).
- Install the lower trim cover onto the upper trim cover in the following way:
- Match the tab slots on the lower trim cover with the locking tabs on the upper trim cover.
- Tilt the lower trim cover up.
- Slide the lower trim cover forward until the locking tabs snap into the tab slots.
- Screw the 2 pan head tapping screws (1) into the lower trim cover (2).
Tighten: Tighten the 2 pan head tapping screws to 3.5 N.m (31 lb in).
- Install the tilt lever into the lower trim cover. Refer to Tilt Lever Replacement - On Vehicle .
- Install the steering wheel onto the steering column. Refer to Steering Wheel Replacement .
- Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM in SIR.
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.