Tools Required

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

J 42759 Ignition Switch Connector Release Tool

Insert J 42759 into the electronic lock module assembly (1) and slide the ignition and key alarm switch assembly (2) in.

Fig 1: Key Alarm Switch Assembly
Courtesy of GENERAL MOTORS CORP.
Push the key alarm connector (1) into the electronic lock module assembly (2).
Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
Install the passkey connector into the electronic lock module assembly (2).

Fig 2: Passkey Connector
Courtesy of GENERAL MOTORS CORP.
Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).

Fig 3: Bulkhead Connector
Courtesy of GENERAL MOTORS CORP.

Important: The abrasion sleeve must be installed back onto the steering column wire harness assembly. The electronic lock module assembly wires and connector must be hanging out of the middle of the abrasion sleeve.
Attach the wire harness strap (2) to the wire harness assembly (1) and the steering column.
Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle (Column Shift Snap On Shrouds) or Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift) .
Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .