Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- If necessary, perform the following steps:
- Assemble the cylinder head. Refer to Cylinder Head Assemble (LY7) or Cylinder Head Assemble (LLT or LCS) .
- Install the camshaft. Refer to Camshaft Installation - Left Side (LY7) or Camshaft Installation - Left Side (LCS) .
- Install the exhaust manifold to the cylinder head. Refer to Exhaust Manifold Installation - Left Side .
- Install a NEW cylinder head gasket.
- Carefully install the cylinder head with the exhaust manifold to the engine. Refer to Cylinder Head Installation - Left Side (LY7) or Cylinder Head Installation - Left Side (LCS) .
- Install the catalytic converter to the exhaust manifold.
- Connect the wiring harness electrical connector located at the side of the cylinder head.
- Install the coolant temperature sensor electrical connector.
- Install the oil level indicator. Refer to Oil Level Indicator Tube Replacement .
- Install the left bank secondary timing chain. Refer to Secondary Camshaft Intermediate Drive Chain Replacement - Left Side .