LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1526 (Engine Mechanical - 3.5L (L66)) >> Repair Instructions >> On Vehicle Repair Instructions >> Camshaft Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Camshaft Oil Seal Into Cylinder Head
    GM1197325Courtesy of GENERAL MOTORS CORP.
  1. Use the EN 46334  to install the seal (223) into the cylinder head. See Special Tools . Rotate the bolt clockwise until the tool bottoms in the cylinder head bore.
    2. NOTE: Refer to Fastener Notice .
  2. Install the cover, NEW seal, and bolts.

    Tighten:  Tighten the bolts to 22 N.m (16 lb ft).

  3. Install the camshaft sprocket. Refer to Camshaft Drive Sprocket Replacement - Left Side  and Camshaft Drive Sprocket Replacement - Right Side .
scientia non olet · About LEMON Manuals