Compressor Clutch Coil Removal (V5 - Direct Mount)

Tools Required 

• J 41790  Compressor Holding Fixture
• J 8433  Compressor Pulley Puller
• J 8433-3  Forcing Screw
• J 33025  Clutch Coil Puller Legs
• J 33023-A  Puller Pilot

1. Install the compressor onto the J 41790  .
   Fig 1: Compressor & J 41790

   Courtesy of GENERAL MOTORS CORP.
2. Install the J 33023-A  onto the front head of the compressor.
3. Remove the compressor clutch plate and hub assembly. Refer to Compressor Clutch Plate and Hub Assembly Removal (V5 - Direct Mount)  or Compressor Clutch Plate and Hub Assembly Removal (V5 - Conventional Mount) .
4. Remove the compressor rotor and bearing assembly. Refer to Clutch Rotor and/or Bearing Removal (V5 - Direct Mount)  or Clutch Rotor and/or Bearing Removal (V5 - Conventional Mount) .
   Fig 2: Front Head Of Compressor, J 33023-A & J 41790

   Courtesy of GENERAL MOTORS CORP.
5. Mark the clutch coil terminal location (2) on the compressor front head.
6. Install the J 33025  onto the J 8433  .
7. Install the J 8433  onto the compressor clutch coil (1) and tighten the puller leg bolts.
8. Tighten the center forcing screw J 8433-3  of the compressor pulley puller J 8433  against the puller pilot to remove the compressor clutch coil from the compressor.
   Fig 3: Clutch Coil Terminal Location, Clutch Coil & Special Tools

   Courtesy of GENERAL MOTORS CORP.