LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 4.3L >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Level Indicator and Tube Replacement >> Installation Procedure

Installation Procedure

  1. Install the lower half of the oil level indicator tube to the engine. Refer to OIL LEVEL INDICATOR AND TUBE INSTALLATION  .
  2. Apply sealer, GM P/N 12346004 (Canadian P/N 10953480) or equivalent, on the upper oil level indicator tube to the area where the tube fits into the lower half.
  3. Install the oil level indicator tube upper half to the lower half.
    Fig 1: Installing Oil Level Indicator Tube Upper Half To Lower Half
    G01643731Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Secure the engine oil level indicator tube to the transmission fluid fill tube with the bolt.
    Fig 2: Installing Engine Oil Level Indicator Tube To Transmission Fluid Fill Tube
    G01643732Courtesy of GENERAL MOTORS CORP.

    Tighten 

    Tighten the bolt to 12 N.m (106 lb in).

  5. Install the oil level indicator.
  6. Install the engine cover. Refer to ENGINE COVER REPLACEMENT in Interior Trim.
scientia non olet · About LEMON Manuals