Turn Signal Cancel Cam and Bearing Thrust Washer - Disassemble - Off Vehicle

Tools Required

• J 23653-SIR Steering Column Lock Plate Compressor
• J 42137  Cam Orientation Plate Adapter. See Special Tools and Equipment .

Fig 1: Compressing Cam Orientation Plate Using J 23653-SIR & J 42137
Courtesy of GENERAL MOTORS CORP.
CAUTION: Refer to SIR CAUTION in Cautions and Notices.
1. Disable the inflatable restraint steering wheel module. Refer to DISABLING SYSTEM in SIR.
IMPORTANT: Let the inflatable restraint steering wheel module coil hang freely after removal.
2. Remove the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil - Disassemble - Off Vehicle .
3. Remove the bearing retainer using J 23653-SIR and J 42137  .
4. Remove J 23653-SIR and J 42137  .
5. Discard the bearing retainer.
Fig 2: Thrust Washer, Upper Bearing Spring, Turn Signal Cancel Cam Assembly & Cam Orientation Plate
Courtesy of GENERAL MOTORS CORP.
6. Remove the following parts from the steering shaft assembly:
   1. The cam orientation plate (4)
   2. The turn signal cancel cam assembly (3)
   3. The upper bearing spring (2)
   4. The thrust washer (1)