LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Inflatable Restraint Steering Wheel Module Coil - Disassemble - Off Vehicle

Inflatable Restraint Steering Wheel Module Coil - Disassemble - Off Vehicle

    Fig 1: View Of Steering Column Wire Harness Assembly & Wire Harness Strap
    GM415293Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR CAUTION in Cautions and Notices.
  1. Disable the inflatable restraint steering wheel module. Refer to DISABLING SYSTEM in SIR.
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle (Column Shift Snap On Shrouds)  or Steering Column Trim Covers - Disassemble - Off Vehicle (Floor Shift) .
    3. IMPORTANT: The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector is coming out of the abrasion sleeve for installation purposes.
  3. Remove the wire harness assembly (1) from the wire harness strap (2).
  4. Disconnect the inflatable restraint steering wheel module coil connector from the turn signal switch assembly connector.
    5. Fig 2: Steering Wheel Module Coil, Retaining Ring & Wave Washer
    GM415294Courtesy of GENERAL MOTORS CORP.
  5. Remove the retaining ring (3) from the steering column shaft assembly by using snap ring pliers.
  6. Remove the inflatable restraint steering wheel module coil (2) from the steering column shaft assembly.
  7. Remove the wave washer (1) from the steering column shaft assembly.
scientia non olet · About LEMON Manuals