LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Steering Column >> Repair Instructions >> Horn Switch Replacement - On Vehicle >> Removal Procedure

Removal Procedure

    Fig 1: View Of Horn Plunger At Steering Column
    GM399638Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SERVICING THE SIR SYSTEM CAUTION in Cautions and Notices.
  1. Disable the SIR system. Refer to DISABLING SYSTEM in SIR.
  2. Remove the Inflatable Restraint Steering Wheel module. Refer to REMOVAL & INSTALLATION (DRIVER-SIDE) in SIR.
  3. Remove the horn plunger from the steering column by pressing inward to the stop and rotating horn plunger 90 degrees.
    4. Fig 2: View of Horn Contact Plate, Steering Wheel & Screws
    GM776565Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the horn contact plate (2) captured screws (1,4) from the steering wheel (3).
  5. Remove the horn switch (2) from the steering wheel (3).
scientia non olet · About LEMON Manuals