LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Steering Column >> Repair Instructions >> Horn Switch Replacement - On Vehicle >> Installation Procedure

Installation Procedure

    Fig 1: View of Horn Contact Plate, Steering Wheel & Screws
    GM776565Courtesy of GENERAL MOTORS CORP.
  1. Install the horn switch (2) to the steering wheel (3).
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Connect the horn contact plate (2) captured screws (1,4) to the steering wheel (3).

    Tighten:  Tighten the horn contact plate captured screws to 5.5 N.m (50 lb in).

    3. Fig 2: View Of Horn Plunger At Steering Column
    GM399638Courtesy of GENERAL MOTORS CORP.
  3. Install the horn plunger to the steering column.
  4. Install the inflator module. Refer to REMOVAL & INSTALLATION (DRIVER-SIDE) in SIR.
  5. Enable the SIR system. Refer to ACTIVATING SYSTEM in SIR.
scientia non olet · About LEMON Manuals