LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2001 >> C3500 HD 8.1 G, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel And Steering Column - Tilt >> Repair Instructions >> Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle >> Installation Procedure

Installation Procedure

    Fig 1: View Of Steering Column Wire Harness Assembly & Wire Harness Strap
    GM415293Courtesy of GENERAL MOTORS COMPANY
  1. Install the multifunction turn signal/hazard switch to the steering column.
  2. Refer to FASTENER NOTICE in Cautions and Notices.

    Install the screws retaining the multifunction switch to the steering column.

    Tighten 

    Tighten the screws to 6 N.m (53 lb in).

  3. Connect the park position switch electrical connection.
  4. Install the wire harness straps to the steering column wire harness (1).
    5. Fig 2: Turn Signal & Multifunction Switch Assembly Connectors
    GM306234Courtesy of GENERAL MOTORS COMPANY
  5. Install the gray and black wiring harness connectors (1) to the column bulkhead connector.
  6. Connect the automatic transmission shift lock control electrical connector.
    7. Fig 3: View Of Steering Column Electrical Connectors
    GM401496Courtesy of GENERAL MOTORS COMPANY
  7. Install the steering column bulkhead connector to the vehicle wire harness.

    Tighten 

    Tighten the center screw to 6 N.m (53 lb in).

  8. Install the wire straps on the steering column wire harness.
  9. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
  10. Tighten the steering column bracket nuts.

    Tighten 

    Tighten the nuts to 30 N.m (22 lb ft).

  11. Install the knee bolster. Refer to Knee Bolster Replacement (Luxury) , Knee Bolster Replacement (Non-Luxury) in Instrument Panel, Gauges and Console.
  12. Enable the SIR system. Refer to Enabling the SIR System in SIR.
scientia non olet · About LEMON Manuals